Surface area matters: An evaluation of swabs and surface area for environmental surface sampling of healthcare pathogens.

Flocked and foam swabs were used to sample five healthcare pathogens from three sizes of steel and plastic coupons; 26 cm2, 323 cm2, and 645 cm2. As surface area increased, 1-2 log10 decrease in recovered organisms (P < .05) was observed. Sampling 26-cm2 yielded the optimal median percent of pathogens recovered.

The effect of disinfectants on the microbial community on environmental healthcare surfaces using next generation sequencing.

BACKGROUND: Healthcare-associated infections are a significant economic burden and cause of avoidable morbidity and mortality within healthcare systems. The contribution of environmental contamination to healthcare-associated infection transmission has been recognized, but the mechanisms by which transmission occurs are still being investigated. The objective of this study was to characterize the microbial communities of disinfected, non-critical healthcare surfaces using next generation sequencing technology. METHODS: Composite environmental surface samples were from high-touch surfaces in rooms of patients isolated for infections with multidrug-resistant organisms during their hospitalization. Information on the disinfectant product used and cleaning type (routine or terminal) was collected. 16S rRNA gene amplicon sequencing and analysis were performed. Community analysis was conducted to determine the bacterial composition and compare the detection of target pathogens by culture from 94 Contact Precaution rooms. RESULTS: Overall percent agreement between culture and sequence methods ranged from 52%-88%. A significant difference was observed in bacterial composition between rooms cleaned with bleach and those cleaned with a quaternary ammonium compound for composite 2 (overbed table, intravenous pole, and inner room door handle) (ANOSIM R = 0.66, P = .005) but not composite 1 (bed rails, television remote control unit, call buttons, and telephone). CONCLUSIONS: Surfaces in bleach-cleaned rooms contained a higher proportion of gram-positive microbiota, whereas rooms cleaned with quaternary ammonium compound contained a higher proportion of gram-negative microbiota, suggesting disinfectant products may impact the healthcare environment microbiome.

Development of a rapid-viability PCR method for detection of Clostridioides difficile spores from environmental samples.

Clostridioides difficile is a common pathogen that is well known to survive for extended periods of time on environmental healthcare surfaces from fecal contamination. During epidemiological investigations of healthcare-associated infections, it is important to be able to detect whether or not there are viable spores of C. difficile on surfaces. Current methods to detect C. difficile can take up to 7 days for culture and in the case of detection by PCR, viability of the spores cannot be ascertained. Prevention of C. difficile infection in healthcare settings includes adequate cleaning and disinfection of environmental surfaces which increases the likelihood of detecting dead organisms from an environmental sample during an investigation. In this study, we were able to adapt a rapid-viability PCR (RV-PCR) method, first developed for detection of viable Bacillus anthracis spores, for the detection of viable C. difficile spores. RV-PCR uses the change in cycle threshold after incubation to confirm the presence of live organisms. Using this modified method we were able to detect viable C. difficile after 22 h of anaerobic incubation in Cycloserine Cefoxitin Fructose Broth (CCFB). This method also used bead beating combined with the Maxwell 16 Casework kit for DNA extraction and purification and a real-time duplex PCR assay for toxin B and cdd3 genes to confirm the identity of the C. difficile spores. Spiked environmental sponge-wipes with and without added organic load were tested to determine the limit of detection (LOD). The LOD from spiked environmental sponge-wipe samples was 104 spores/mL but after incubation initial spore levels of 101 spores/mL were detected. Use of this method would greatly decrease the amount of time required to detect viable C. difficile spores; incubation of samples is only required for germination (22 h or less) instead of colony formation, which can take up to 7 days. In addition, PCR can then quickly confirm or deny the identity of the organism at the same time it would confirm viability. The presence of viable C. difficile spores could be detected at very low levels within 28 h total compared to the 2 to 10-day process that would be needed for culture, identification and toxin detection.

Assessment of the Overall and Multidrug-Resistant Organism Bioburden on Environmental Surfaces in Healthcare Facilities.

OBJECTIVE To determine the typical microbial bioburden (overall bacterial and multidrug-resistant organisms [MDROs]) on high-touch healthcare environmental surfaces after routine or terminal cleaning. DESIGN Prospective 2.5-year microbiological survey of large surface areas (>1,000 cm2). SETTING MDRO contact-precaution rooms from 9 acute-care hospitals and 2 long-term care facilities in 4 states. PARTICIPANTS Samples from 166 rooms (113 routine cleaned and 53 terminal cleaned rooms). METHODS Using a standard sponge-wipe sampling protocol, 2 composite samples were collected from each room; a third sample was collected from each Clostridium difficile room. Composite 1 included the TV remote, telephone, call button, and bed rails. Composite 2 included the room door handle, IV pole, and overbed table. Composite 3 included toileting surfaces. Total bacteria and MDROs (ie, methicillin-resistant Staphylococcus aureus, vancomycin-resistant enterococci [VRE], Acinetobacter baumannii, Klebsiella pneumoniae, and C. difficile) were quantified, confirmed, and tested for drug resistance. RESULTS The mean microbial bioburden and range from routine cleaned room composites were higher (2,700 colony-forming units [CFU]/100 cm2; ≤1-130,000 CFU/100 cm2) than from terminal cleaned room composites (353 CFU/100 cm2; ≤1-4,300 CFU/100 cm2). MDROs were recovered from 34% of routine cleaned room composites (range ≤1-13,000 CFU/100 cm2) and 17% of terminal cleaned room composites (≤1-524 CFU/100 cm2). MDROs were recovered from 40% of rooms; VRE was the most common (19%). CONCLUSIONS This multicenter bioburden summary provides a first step to determining microbial bioburden on healthcare surfaces, which may help provide a basis for developing standards to evaluate cleaning and disinfection as well as a framework for studies using an evidentiary hierarchy for environmental infection control. Infect Control Hosp Epidemiol 2016;1426-1432.

A biofilm model developed to investigate survival and disinfection of Mycobacterium mucogenicum in potable water.

Water in healthcare environments can be a source for healthcare-associated infections (HAI). However, information on the exposure risk to opportunistic pathogens in potable water distribution systems (PWDS) is lacking. Laboratory studies characterizing the interaction of opportunistic pathogens with biofilms are needed to understand their role in water systems within healthcare facilities. A stable, repeatable, PWDS multi-species biofilm model comprising Sphingomonas paucimobilis, Methylobacterium sp., Delftia acidovorans, and Mycobacterium mucogenicum was developed in the CDC Biofilm Reactor (CBR), reaching 6 log(10) CFU cm(-2) within 6 days. The model was used to investigate the interaction of the opportunistic pathogen M. mucogenicum with the other species, and to determine the efficacy of monochloramine (NH(2)Cl) as a disinfectant against 2-week-old biofilms. Addition of 1 or 2 mg l(-1) NH(2)Cl resulted in the same or an increased log density of viable M. mucogenicum in the biofilm while inactivating some of the Proteobacteria. Although M. mucogenicum preferentially resided in the biofilm, NH(2)Cl exposure caused release of viable M. mucogenicum from the biofilm into the water. Additional studies with this model should determine if sodium hypochlorite has a comparative effect and if other nontuberculous mycobacteria (NTM) respond to NH(2)Cl similarly.

Multiphasic approach reveals genetic diversity of environmental and patient isolates of Mycobacterium mucogenicum and Mycobacterium phocaicum associated with an outbreak of bacteremias at a Texas hospital.

Between March and May 2006, a Texas hospital identified five Mycobacterium mucogenicum bloodstream infections among hospitalized oncology patients using fluorescence high-performance liquid chromatography analysis of mycolic acids. Isolates from blood cultures were compared to 16 isolates from environmental sites or water associated with this ward. These isolates were further characterized by hsp65, 16S rRNA, and rpoB gene sequencing, hsp65 PCR restriction analysis, and molecular typing methods, including repetitive element PCR, random amplified polymorphic DNA PCR, and pulsed-field gel electrophoresis (PFGE) of large restriction fragments. Three of five patient isolates were confirmed as M. mucogenicum and were in a single cluster as determined by all identification and typing methods. The remaining two patient isolates were identified as different strains of Mycobacterium phocaicum by rpoB sequence analysis. One of these matched an environmental isolate from a swab of a hand shower in the patient's room, while none of the clinical isolates of M. mucogenicum matched environmental strains. Among the other 15 environmental isolates, 11 were identified as M. mucogenicum and 4 as M. phocaicum strains, all of which were unrelated by typing methods. Although the 16S rRNA gene sequences matched for all 14 M. mucogenicum isolates, there were two each of the hsp65 and rpoB sequevars, seven PCR typing patterns, and 12 PFGE patterns. Among the seven M. phocaicum isolates were three 16S rRNA sequevars, two hsp65 sequevars, two rpoB sequevars, six PCR typing patterns, and six PFGE patterns. This outbreak represents the first case of catheter-associated bacteremia caused by M. phocaicum and the first report of clinical isolates from a U.S. hospital. The investigation highlights important differences in the available typing methods for mycobacteria and demonstrates the genetic diversity of these organisms even within narrow confines of time and space.

Survival of Burkholderia pseudomallei on Environmental Surfaces.

The survival of the biothreat agent Burkholderia pseudomallei on the surfaces of four materials was measured by culture and esterase activity analyses. The culture results demonstrated that this organism persisted for <24 h to <7 days depending on the material, bacterial isolate, and suspension medium. The persistence determined by analysis of esterase activity, as measured with a ScanRDI solid-phase cytometer, was always longer than the persistence determined by culture analysis.